Kohler KD62V12 Service And Repair Manual page 174

Repair
Exhaust gas system
u Tighten screws 16 to torque.
Fig. 197: Installing pipes
u Insert o-ring 9 in distribution block 7.
u Position distribution block 7 with screws 6 on oil entry of turbocharger bracket.
u Tighten screws 6 to torque.
u Install and tighten flange joints 1, 8 to torque.
u Grease orifice 12.
u Install pipe 10 with orifice 12, screws 11 and seal 12 between flange joint 8 and crankcase.
u Install pipe 2 with flange joint 1 on oil entry of turbocharger bracket.
u Tighten screws 11 to torque.
u Install plate 4 and clamps 3 with screws 5.
u Tighten screws 5 to torque.
Specific values
Not applicable.
Tightening specifications
Refer to standard tightening torques.
page 264.)
174
(For more information see: 5.3 Standard tightening torques,
© 2021 by Kohler Co. All rights reserved.
Service and Repair Manual
KD62V12 33525088601_7_1 EN_US
2021-07