Kohler KD62V12 Service And Repair Manual page 182

Repair
Exhaust gas system
Installation
u Install compensators 1 with seals 2 and V-clamps 3.
u Tighten V-clamps 3 to torque.
Specific values
Not applicable.
Tightening specifications
Fig. 207: V-clamps
1 410AF
Tab. 41: Tightening specifications table
*Lubricants:
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
O = Engine oil
XX = Loctite 243
YY = Loctite 577
**Refer to screws reuse rules.
marking, page 264.)
Exhaust pipes removal and installation
Previous tasks
q Remove exhaust gas turbocharger.
installation (SL 233), page 165.)
182
Key Screw specifications
M8x1.25
(For more information see: 5.3.2 Screws pre-tightening, reuse and
© 2021 by Kohler Co. All rights reserved.
MH Yes
(For more information see: 3.8.3 Turbocharger removal and
Service and Repair Manual
Torque Angle (°)
± 5%
1 20 Nm -
15 ft-lb
KD62V12 33525088601_7_1 EN_US
± 5°
-
2021-07