Kohler KD62V12 Service And Repair Manual page 149

Service and Repair Manual
Tightening specifications
Fig. 172: Screws
1 230AB
2 230AH
Tab. 35: Tightening specifications table
*Lubricants:
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
O = Engine oil
XX = Loctite 243
YY = Loctite 577
**Refer to screws reuse rules.
marking, page 264.)
3.7.3 Charge air cooler removal and installation (SL 220)
Previous tasks
q Remove venting line.
page 197.)
q Drain LT coolant circuit until level is lower than the base of the charge air coolers.
KD62V12 33525088601_7_1 EN_US
2021-07
Key Screw specifications
ISO 4014 M12x1.75x80-10.9-FLZN
EN 1665 M10x1.5x80-10.9-FLZN
(For more information see: 5.3.2 Screws pre-tightening, reuse and
(For more information see: 3.10.1 Venting line removal and installation,
© 2021 by Kohler Co. All rights reserved.
Torque
± 5%
- Yes 1 40 Nm
30 ft-lb
- Yes 1 43 Nm
32 ft-lb
Repair
Charge air system
Angle (°)
± 5°
- -
- -
149