Programming And Running Other Software On The F28003X Launchpad; Figure 2-2. Launchpad Demo Serial Terminal - Ti Logo; Figure 2-3. Launchpad Demo Serial Terminal - Adc Sampling - Texas Instruments C2000 F28003x Series User Manual

www.ti.com
After a few moments, the ADC value sampled on the ADCINA6 pin will appear in the bottom right corner of the
terminal and be updated each second. Using a jumper wire connect the ADCINA6 header to a 3.3V, GND, or
other 0-3.3V signal to see the on-screen value change.

Figure 2-3. LaunchPad Demo Serial Terminal - ADC Sampling

2.3 Programming and Running Other Software on the F28003x LaunchPad

The software packages described in
and run on the F28003x LaunchPad. If you installed the
installation path of C:\ti\c2000\C2000Ware_<version>, you can find driverLib based example applications in
C:\ti\c2000\C2000Ware_<version>\examples\F28003x. The on-board XDS110 is used with the On-Chip Flash
Programmer tool to program applications to the F28003x LaunchPad.
Follow these steps to program example applications onto the F28003x LaunchPad development kit using the
on-board XDS110 debug probe:
1. Install Code Composer Studio (CCS)
2. Connect the USB-A cable plug in to an available USB port on the PC and plug the USB Type-C™ plug to the
port (USB101) on the F28003x LaunchPad.
3. Verify the following LEDs are illuminated:
a. LED7, at the top left of the board, indicating 5 V USB power.
b. LED0 indicating 3.3 V power to the XDS110 debug probe.
c. LED1 indicating 3.3 V power to the F280039C MCU.
4. Install Windows XDS110 and Virtual COM Port drivers if prompted. Installation instructions can be found at
XDS110 Product Page.
SPRUJ31 – APRIL 2022
Submit Document Feedback

Figure 2-2. LaunchPad Demo Serial Terminal - TI Logo

Section 2.1 include example projects that can be loaded
on a PC running Microsoft Windows.
Copyright © 2022 Texas Instruments Incorporated
C2000WARE software to the default
™
C2000 F28003x Series LaunchPad
Software Development
™
Development Kit 7