Safety Information; Safety Instructions - R&S RTC1002 Getting Started

®
R&S RTC1000
1

Safety Information

The R&S RTC1000 digital oscilloscope is designed for measurements on circuits
that are only indirectly connected to the mains or not connected at all. It is not
rated for any measurement category.
The instrument is rated for pollution degree 2 - for indoor, dry location use where
only non-conductive pollution occurs. Temporary conductivity caused by conden-
sation is possible.
The instrument must be controlled by personnel familiar with the potential risks of
measuring electrical quantities. Observe applicable local or national safety regula-
tions and rules for the prevention of accidents.
Safety information is part of the product documentation. It warns you about the
potential dangers and gives instructions how to prevent personal injury or dam-
age caused by dangerous situations. Safety information is provided as follows:
● The "Basic Safety Instructions" in different languages are delivered as a prin-
ted brochure with the instrument.
● Throughout the documentation, safety instructions are provided when you
need to take care during setup or operation.
1.1

Safety Instructions

To prevent electric shock, personal injury or fire, follow these rules:
● Do not open the instrument casing.
● Do not use the instrument if you detect or suspect any damage of the instru-
ment or accessories.
● Do not operate the instrument in wet, damp or explosive atmospheres.
● Make sure that the instrument is properly grounded.
● Do not use the instrument to ascertain volt-free state.
● Do not exceed the voltage limits given in
on page 16.
Getting Started 1335.7346.02 ─ 06
Safety Information
Chapter 4.1.1, "Input
Safety Instructions
Connectors",
5