Starting Up And Shutting Down - R&S RTC1002 Getting Started

®
R&S RTC1000
2. Connect the power cable to the socket outlet.
3. Switch the main power switch at the rear of the instrument to position I.
The [ON/OFF] key lights up when the instrument is in standby mode. The key
is located next to the upper right corner of the screen.
You can leave the main power switch on to preserve your last instrument settings.
To disconnect from power supply, power off the instrument.
3.3.2

Starting Up and Shutting Down

To start up the instrument
1. Make sure that the R&S RTC1000 is connected to the AC power supply and
the main power switch on the rear panel is in position I.
2. Press the [ON/OFF] key. The key is located next to the upper right corner of
the screen.
The instrument performs a system check and starts the firmware. If the previ-
ous session was terminated regularly, the oscilloscope uses the last settings.
Table 3-1: Colors of the [ON/OFF] key
Unlit
Red
Warm-up and prepare the instrument
Make sure that the instrument has been running and warming up before you
start the self-alignment and the measurements. The minimum warm-up time
is about 20 min.
To shut down the instrument to standby state
► Press the [ON/OFF] key.
All current settings are saved, and the software shuts down. Now it is safe to
power off the instrument.
Getting Started 1335.7346.02 ─ 06
Instrument is on: firmware is working
Standby: instrument is off, main power switch is on
Preparing for Use
Starting the Instrument
12