Rear Panel - R&S RTC1002 Getting Started

®
R&S RTC1000
[Pattern Generator] (8)
Connectors for the pattern generator P0, P1, P2, P3.
[Probe Comp.] (8)
Probe compensation terminal to support adjustment of passive probes to the
oscilloscope channel.
[Aux Out] (10)
Multi-purpose BNC output that can function as pass/fail and trigger output, output
for component testing, and as function generator output (with option R&S RTC-
B6).
[USB] type A (11)
USB 2.0 type A interface to connect a USB flash drive for storing and reloading
instrument settings and measurement data, and to update the firmware.
4.2

Rear Panel

Figure 4-2 shows the rear panel of the R&S RTC1000 with its connectors.
On the back panel of the instrument, you find Ethernet and USB interfaces.
Optional interfaces are not available.
Getting Started 1335.7346.02 ─ 06
Square wave signal for probe compensation.
Ground connector for probes.
Instrument Tour
Rear Panel
18