Turn Housing; Post-Installation Check - Endress+Hauser Levelflex M FMP45 Operating Instructions Manual

Levelflex M FMP45 with HART/4...20 mA
Endress + Hauser
3.5

Turn housing

After mounting, the housing can be turned 350° in order to simplify access to the display and the
terminal compartment. Proceed as follows to turn the housing to the required position:
• Undo the fixing screws (1)
• Turn the housing (2) in the required direction
• Tighten up the fixing screws (1).
F12/F23 housing
2
1
3.6

Post-installation check

After the measuring instrument has been installed, perform the following checks:
• Is the measuring instrument damaged (visual check)?
• Does the measuring instrument correspond to the measuring point specifications such as process
temperature/pressure, ambient temperature, measuring range, etc.?
• Are the measuring point number and labeling correct (visual check)?
• Is the measuring instrument adequately protected against rain and direct sunlight (see → ä 65)?
T12 housing
2
1
allen key
4 mm/0.1"
Installation
L00-FMP41Cxx-17-00-00-de-002
25