Table of Contents
Advertisement
• The heat pump is on standby
• Press
for 2 seconds:
the last water temperature measured is then displayed
This value varies depending on the last temperature recorded during the last connection.
If no water flow was present during the last connection, the screen will display the value
• Set the desired temperature (called the "temperature setpoint" ) (see § ''2.4.2 Adjusting the temperature setpoint'').
After the start-up steps for your heat pump:
• Shut down the water circulation temporarily (by stopping the filtration or closing valve B or C) to check that you
appliance stops after a few seconds (via the activation of the flow switch).
• Reduce the setpoint temperature to below the water temperature to check that the heat pump stops operating.
• Switch off the heat pump by pressing and holding
2.4 I User functions
2.4.1 Locking/unlocking the keyboard
To lock or to unlock the keypad,
2.4.2 Adjusting the temperature setpoint
• Press
or
: the temperature setpoint is displayed and flashes,
• Press
to increase the temperature by 0.5 °C*,
• Press
to reduce the temperature by 0.5 °C**.
• Press
to confirm the desired setpoint temperature.
• The settings screen is automatically exited after 3 seconds of inactivity on the keypad or by pressing and releasing
The heat pump stops automatically when the pool reaches the required temperature.
*Maximum setpoint temperature = 32 °C.
**Minimum setpoint temperature = 15 °C.
If the setpoint temperature has not been confirmed by pressing
returns to the home screen (which takes place automatically after 3 seconds of inactivity on the keypad or
by pressing and releasing
2.4.3 Activating/deactivating "silence" mode
«Silence» mode is used to reduce the noise level emitted by the heat pump.
The appliance will operate for a longer period of time with less power, however with a lower noise level.
There are 2 ways to activate the "Silence" mode:
1
method
st
• Press and release
2
method
nd
• Press and hold
• Press
or
to display:
• Press and release
• The home screen automatically reappears after 60 seconds of inactivity on the keypad or by pressing and releasing
To deactivate the "Silence" mode, redo the manipulation, the symbol
13
(software version vary depending on the appliances) is displayed for 4 seconds,
press and hold
).
, the symbol
will light up.
.
, the symbol
will light up.
.
for 2 seconds and check that it stops
and
simultaneously for 3 seconds:
, it will not be saved if the interface
will go out.
.
.
or
.
.
.
Advertisement
Table of Contents
