Table of Contents
Advertisement
Understanding the printer menus
Use
Alarms
Alarm Control
Cartridge Alarm
Staple Alarm
Hole Punch Alarm
Timeouts
Standby Mode
Disabled
1–240
Timeouts
Sleep Mode
Disabled
1‑120
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
Timeouts
Screen Timeout
15–300
Timeouts
Prolong Screen Timeout
On
Off
To
Set an alarm to sound when operator intervention is required.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. This
sounds three quick beeps.
•
Off is the factory default setting for Cartridge Alarm, Staple
Alarm, and Hole Punch Alarm.
•
Continuous repeats three beeps every 10 seconds.
Set the amount of time in minutes before the scanner enters a
lower power state.
Note: 15 is the factory default setting.
Set the amount of time in minutes the scanner waits after a job is
printed before the scanner and the printer go into a reduced power
state.
Notes:
•
20 is the factory default setting.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select the lowest setting if the scanner and the printer share
an electrical circuit with room lighting or you notice lights
flickering in the room.
•
Select a high setting if the scanner and the printer are in
constant use. Under most circumstances, this keeps the
printer ready to print with minimum warm‑up time.
•
"Disabled" appears only if Energy Conserve is set to Off.
Print a job while the display is off.
Note: Display on when printing is the factory default setting.
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
Continue a specified job without returning to the home screen
when the screen timeout timer expires.
Note: Off is the factory default setting.
188
Advertisement
Table of Contents
