Lexmark MX6500 User Manual page 126

Faxing
Scenario 3: VoIP telephone service
To connect:
1
Connect one end of the telephone cable that came with the scanner to the
2
Connect the other end of the cable to the port labeled Phone Line 1 or Phone Port on the VoIP adapter.
Note: The port labeled Phone Line 2 or Fax Port is not always active. VoIP providers may charge additional cost
for the activation of the second phone port.
3
Connect the telephone to the
Tips for this setup:
•
To make sure that the phone port on the VoIP adapter is active, plug an analog telephone into the phone port, and
then listen for a dial tone. If you hear a dial tone, then the port is active.
•
If you need two phone ports for your devices, but do not want to pay additional cost, then do not plug the scanner
into the second phone port. You can use a phone splitter. Plug the phone splitter into the port labeled Phone Line
1 or Phone Port, and then plug the scanner and telephone into the splitter.
Note: Make sure you use a phone splitter, not a line splitter. To make sure that you are using the correct
splitter, plug an analog telephone into the splitter, and then listen for a dial tone.
port of the scanner.
port of the scanner.
126