Table of Contents
Advertisement
www.ti.com
Jumper
J2
J3
J4
J5
J6
J8
J9
J10
J11
J12
J13
J14
J15
J16
J17
J21
J22
J23
J24
J25
J26
J27
J28
J29
J30
J31
6.2
Software Installation
This section presents the steps required to the install the software.
NOTE: Ensure the microSD memory card included in the kit is installed in the microSD socket (P6)
on the back of the simple capture card before connecting the EVM to the computer.
Otherwise, as a result of improper boot up, Windows
PDK as a connected device.
Complete the following steps to install the software:
1. Verify the microSD memory cards are installed on the simple capture card and the ADS86xxEVM
board.
2. Verify jumpers are in the factory-default position and are properly connected to the hardware.
3. Install the ADS86xxEVM-PDK software.
4. Complete the simple capture card device driver installation.
Each task is described in the following subsections.
SBAU245A – June 2015 – Revised July 2015
Submit Documentation Feedback
Table 13. Default Jumper Configuration
Closed between pins 2 and 3
Closed between pins 1 and 2
Closed between pins 2 and 3
Closed between pins 1 and 2
Closed between pins 1 and 2
Closed between pins 2 and 3
Closed between pins 1 and 2
Copyright © 2015, Texas Instruments Incorporated
ADS86xxEVM-PDK Initial Setup
Default Position
Closed
Open
Closed
Open
Open
Open
Closed
Closed
Closed
Closed
Closed
Closed
Open
Closed
Closed
Closed
Closed
Open
Open
cannot recognize the ADS86xxEVM-
®
ADS86xxEVM-PDK Evaluation Module
13
Advertisement
Table of Contents
