Front I/O assembly replacement
Use this information to remove and install the front I/O assembly.
Remove the front I/O assembly
Use this information to remove the front I/O assembly.
"Read the
installation
Guidelines" on
page 45
Before removing the front I/O assembly:
1. Remove the top cover. See "Remove the top cover" on page 57.
2. If the security bezel is installed, remove it. See "Remove the security bezel" on page 53.
3. Disconnect cables of the front I/O assembly from the system board.
To remove the front I/O assembly, complete the following steps:
Watch the procedure. A video of the removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-AQrHuDWK6L3KtHWc6maY_O
• Youku:
http://list.youku.com/albumlist/show/id_50437162
Table 11. Front I/O assembly removal
Figure 40. Server models with 2.5-inch drive bays
Step 1.
Remove the screws that secure the front I/O assembly.
Step 2.
Slide the front I/O assembly out of the assembly bay.
If you are instructed to return the old front I/O assembly, follow all packaging instructions and use any
packaging materials that are provided.
ThinkSystem SR530 Maintenance Manual
70
"Power off
the server
for this task"
on page 14
Figure 41. Server models with 3.5-inch drive bays
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 48