Power Supply; Using A Battery Pack - JVC GY-HM250UG Instructions Manual

Power Supply

To use this camera recorder, you can attach a
battery pack or connect an AC adapter to it.
(A P32 [Using a Battery Pack] )
(A P34 [Using AC Power (DC IN Power)] )
Caution :
Set the [POWER ON/OFF] switch to "OFF"
0
before changing the power supply that operates
this camera recorder.
To charge the battery using a battery charger,
0
purchase a genuine charger that can charge the
recommended battery. n
Charge the battery in the camera recorder. m
0
M
When the battery runs out and the camera
0
recorder shuts down, charge the battery
immediately.

Using a Battery Pack

Charging the Battery
Charge the battery immediately after purchase or
when the battery power is running low.
* The battery is not charged when purchased.
2
4
1
.
32
Power Supply
1 Hold down the lock button (blue) at the
center of the [POWER ON/OFF] switch to set
to "OFF".
2 Attach the supplied battery.
Slide it in until you hear a click.
3 Connect the supplied AC adapter to the
[DC] terminal.
Open the cover of the [DC] terminal and connect
as shown in the diagram.
4 Connect the AC adapter to a power outlet.
The [POWER/CHARGE] lamp blinks during
0
charging and will go out after charging is
complete.
Remove the AC adapter after charging is
0
complete.
Memo :
Blinking of the [POWER/CHARGE] lamp during
0
charging indicates the charge level.
[POWER/CHARGE] Lamp
Alternates between a blinking
orange light (4 times) and
light off (1 second)
Alternates between a blinking
orange light (3 times) and
light off (1 second)
Alternates between a blinking
orange light (2 times) and
light off (1 second)
Alternates between a blinking
orange light (blinks once) and
light off (1 second)
Light goes out
You can charge the battery even when operating
0
the camera recorder using the AC adapter.
3
Charge Level
Less than 25 %
Less than 50 %
Less than 75 %
Less than 100 %
Fully charged