JVC GY-HM250UG Instructions Manual page 129

o Destination Port
Enter the network port number of the live
distribution destination using an integer
between 1 and 65535.
When [Type] is set to "MPEG2-TS/UDP" or
"MPEG2-TS/RTP", the default value is "6504". If
"ZIXI" is set, the default value is "2088".
Memo :
When [Type] is set to "MPEG2-TS/RTP", only
0
even numbers from 2 to 65530 can be specified
for the port number.
When [Type] is set to "MPEG2-TS/RTP" and
0
[SMPTE 2022-1 FEC] is set to "On", N+2 and N
+4 port numbers are also used in addition to the
specified port number (N).
o Stream ID
For setting the registered stream ID of the live
distribution destination.
The default value varies with the product model.
* Enter not more than 63 characters.
o Stream Key
Enter the stream key specified at the live
transmission destination.
There is no default value (blank).
* Enter not more than 63 characters.
Memo :
To enter more than 63 characters for the stream
0
key, you can add "/" at the end of the destination
URL and continue to enter the stream key. You
can also enter from the web browser.
(A P177 [Configuring Settings via a Browser
n] )
(Example)
When the destination URL:
rtmp://myserver.com
and stream key: abcdefgh....
you can connect by changing to the following:
Destination URL:
rtmp://myserver.com/abcdefgh....
Stream key: (no entry)
o Password
For setting the [Stream ID] password.
There is no default value (blank).
* Enter not more than 127 characters. Enter not
more than 31 characters for RTSP/RTP setting.
o Latency
For setting the latency mode.
[Setting Values: High, Medium, RLow,
Minimum(ZIXI Off)]
o Adaptive Bit Rate
If "On" is selected, the bit rate setting value of
live streaming is set to maximum limit, and the
bit rate is changed automatically according to
changes in the network bandwidth.
[Setting Values: On, ROff]
Memo :
[Adaptive Bit Rate] is selectable when [Type] is
0
set to "ZIXI" and [Latency] is set to a value other
than "Minimum(ZIXI Off)".
* The bit rate is displayed on the status screen
only when "On" is set.
o PCR Jitter
Setting to "Low" reduces to PCR jitter of live
streaming.
[Setting Values: Low, RNormal]
Memo :
This item is selectable only when [Type] is set to
0
"MPEG2-TS/UDP".
o SMPTE 2022-1 FEC
Set to "On" to use FEC (Forward Error
Correction).
A transmission system that recovers the missing
packets in the decoding process without having
to retransmit the missing packets.
[Setting Values: On, ROff]
* The decoder must be compatible with SMPTE
2022-1.
o FEC Matrix
For setting the amount of FEC (Forward Error
Correction) overhead for configuring
SMPTE2022-1.
(A P186 [Setting the FEC Matrix] )
Memo :
This item is selectable only when [SMPTE
0
2022-1 FEC] is set to "On".
129
System Menu