Bi-Parting & Dual Gate Systems; Connecting An Interlocked Pair (Dual Gate) - HySecurity HydraSwing 40 Twin Programming And Operations Manual

Bi-Parting & Dual Gate Systems
Configuring two or more operators to work together as an interlocked pair (Primary/Secondary or Sally Port)
or sequenced gate system is easy to do with the Smart Touch Controller (STC). There is no need to order a
special model or any adapters. The area of the board marked Dual Gate employs a 3-wire, RS-485 serial port
for communication between the operators.
NOTE: RS-485 communication is available for networked security systems. For additional information, refer to Connecting
Sequenced Gates on page 70. The HydraSwing Twin is comprised of two gates run with one motor and one Smart Touch
Controller. HydraSwing Twin models are categorized as singular systems, not dual gate systems.
c i p (d G )
OnnectinG an nterLOcked air uaL ate
The Smart Touch Controller provides dual gate connections (two swing gates run by two separate HydraSupply
control units). The STC programming features connect a pair of gate operators in a Primary/Secondary or
interlocked Sally Port configuration. The software establishes the communication protocols when wiring
the two separate gate operators. A Primary/Secondary pair of operators can be set for different open/close
timing sequences (leaf delay feature) and Sally Port gates are often used at correctional facilities. In Sally Port
configurations, one operator cannot open unless the other is fully closed. To learn how to connect the wiring
between operators, review the wiring diagram on the next page.
NOTE: Both HydraSwing gate systems need to have compatible software versions installed on their Smart Touch Controllers.
HydraSwing 80F Dual Gate Systems
67
© 2018 Bi-Parting & Dual Gate Systems MX3636-01 Rev. D