HP 2133 Mini-Note Maintenance And Service Manual page 73

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Keyboard (see
b. Hard drive or solid-state drive (see
c. Top cover (see
d. Audio board (see
e. System board (see
Remove the WLAN module:
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless
module authorized for use in the computer by the governmental agency that regulates wireless devices
in your country or region. If you replace the module and then receive a warning message, remove the
module to restore computer functionality, and then contact technical support through Help and Support.
1. Turn the system board upside down, with the front toward you.
2. Remove the Torx8 T8M2.5×5.0 screw (1) that secures the WLAN module to the system board.
(The edge of the module opposite the slot rises away from the computer.)
3. Remove the WLAN module (2) by pulling the module away from the slot at an angle.
NOTE: WLAN modules are designed with a notch (3) to prevent incorrect insertion.
Reverse this procedure to install the WLAN module.
Battery on page 44).
Keyboard on page 45)
Mass storage device on page
Top cover on page 52)
Audio board (Model 2133 only) on page
System board on page
49)
55)
59)
Component replacement procedures 65