HP 2133 Mini-Note Maintenance And Service Manual page 59

If you have model 2140, remove the hard drive or solid-state drive:
1. Disconnect the drive cable (1) from the connector on the system board (2).
2. Remove the two PM2.0×5.0 screws (1) that secure the rear of the drive to the computer.
3. Loosen the captive PM2.0×5.0 screw (2) that secures the front of the drive to the computer.
4. Grasp the Mylar tab (3) on the drive and slide the drive (4) to the right to release it from the drive
bay.
5. Remove the drive (5) from the drive bay.
Reverse this procedure to install the hard drive or solid-state drive.
Component replacement procedures 51