Download Print this page

HP 2133 Mini-Note Maintenance And Service Manual: 10 Power Cord Set Requirements; Requirements For All Countries And Regions

Hp 2133 mini-note: supplementary guide.
Hide thumbs

Advertisement

10 Power cord set requirements

The wide range input feature of the computer permits it to operate from any line voltage from 100 to 120
volts AC or from 220 to 240 volts AC.
The 3-conductor power cord set included with the computer meets the requirements for use in the
country or region where the equipment is purchased.
Power cord sets for use in other countries and regions must meet the requirements of the country or
region where the computer is used.

Requirements for all countries and regions

The requirements listed below are applicable to all countries and regions:
The length of the power cord set must be at least 1.5 m (5.0 ft) and no more than 2.0 m (6.5 ft).
All power cord sets must be approved by an acceptable accredited agency responsible for
evaluation in the country or region where the power cord set will be used.
The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage
rating of 125 or 250 V AC, as required by the power system of each country or region.
The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard
Sheet C13 connector for mating with the appliance inlet on the back of the computer.
110 Chapter 10 Power cord set requirements

Advertisement

   Related Manuals for HP 2133 Mini-Note

Comments to this Manuals

Symbols: 0
Latest comments: