About The Power Source - Sanwa MT-R RX-493i User Manual

Before Using
ADJUSTING THE ADJUSTABLE TRIGGER
Adjusting the brake trigger
You can adjust brake trigger position accroding
to your fingers by replaceing the included brake
trigger.
Standard Size, +1 Size, +2 Size is included.
1 ) Remove the brake trigger fixing screw.
2 ) Select Brake Trigger according to your fingers.
3 ) Fix the brake trigger by the screw.
*Setting Advice
If you feel much gaps between a finger with trigger, please change brake trigger to +1 or +2.
After changing the brake trigger size, please check the differences while driving.
Combination of trigger position and brake trigger adjustment would give optimic operation by fiting to
personal hand.

ABOUT THE POWER SOURCE

HOW TO PLACE THE TRANSMITTER BATTERIES
<1>Open the battery <2>Place 4 size AA
compartment cover by sliding batteries. Make sure to
the cover to the direction of observe correct polarities.
the arrow while pressing it
lightly.
● About Bind
Each MT-R transmitter has own ID number for transmition. Receiver memorizes the ID number to bind.
After binding, the transmitter can work with the receicer.eceiver and the antenna are installed.
● BINDING is not done at the factory. Please make sure to complete BINDING before use.
● When the receiver is new, make sure to complete BINDING for the transmitter and the new receiver.
● Make sure to use the set of the transmitter and the receiver that completed BINDING.
*About details of bind, please refer p.43-44 in this manual.
7 7
Brake trigger fixing screw
<3>Align the convex part of
the battery compartment cover
and the groove of the battery
compartment, slide the cover to
the direction of the arrow and
close tightly.
ABOUT BIND
Name of Each Part of Transmitter
Brake trigger
( +1 )
( +2 )
Trim 2
( TRM 2 )
Strap Hole
Switch 3
( SW 3 )
Switch 1
( SW 1 )
Display Panel
LED
▲
▼
Trm2 Trm1
Trim 1
( TRM 1 )
Steering Wheel
Switch 2
Sw3
( SW 2 )
Sw1
Trim 3
( TRM 3 )
Throttle Trigger
Internal Antenna
Power Switch
Trigger Position
Adjusting Screw
8