Sanwa MT-R RX-493i User Manual page 17

How to Use Each Feature
AUX
● AUX menu sets the performance of AUX1 and AUX2 (3ch, 4ch). You can choose from STEP AUX (STEP),
POINT AUX (POINT), 4WS (4-Wheel Steering: Coordinate Phase, Opposite Phase). MOA (Motor On
Axle), AUX-MIX (AUX Mixing: ST → AUX/TH-AUX) and CODE-AUX.
4-WHEEL STEERING [4WS]
● With the operation of assigned Trim or Switch, control the motion of the 4 Wheel Steering.
1) Select [AUX] with up and down key.
2) Change [SET] menu with enter.
*Switch CH to SET with up and down key.
2) Type setting (4WS)
Select [4WS] on AUX TYPE setting with up and down key.
4) Mode setting
Set 4WS working mode to used method.
○Setting Range: 2 mode / 3 mode/ 4 mode
○Default: 4 mode
2mode 3mode
F-ST F-ST
REV
REV
NOR
*Please refer the above picture for working mode.
5) Working mode setting
Enter working mode setting and change the mode
with up and down key.
*In case of changing mode while driving,
please asign workig mode on trim or switch.
○Setting range: F-ST / REV / NOR / R-ST
* Switch working mode by mode setting on SET.
* Rear steering servo will work on AUX 1 or AUX channel
by setting 4WS.
*Operating range can be set by
EPA (End Point Adjustment, P.24).
31
AUX
Shortcut for Key Assign
4mode
Switch CH to SET with up and down key.
Select SET with enter.
F-ST
REV
NOR
R-ST
Servo Monitor
Switch Working Mode
Steering Working Image
F-ST
L side Neutral
REV
L side Neutral
NOR
L side Neutral
R-ST
L side Neutral
FRONT-REAR WHEEL SEPARATE DRIVE [MOA]
● By setting Motor On Axle (MOA), you can adjust the drive ratio of front and rear wheels of a front-rear dual
motor car.
1) Select [AUX] with up and down key.
2) Change [SET] menu with enter.
3) TYPE setting (MOA)
Select [MOA] on AUX TYPE setting with up and down key.
4) MODE setting
Set MOA drive ratio to the used method.
Setting Range: 1/2/5/10/20/25/50/100
Default: 10
*Connect the speed controller for controlling the rear motor
to the channel (AUX1/AUX2) that is set to MOA.
*When using, assign the features to switch or trim
or operate with up and down key.
Front Drive
Rear Drive
*By changing the ratio, you can adjust the gear ratio of front-rear.
R side
R side
R side
R side
MOA Motion Image
Front Drive Front Drive
Rear Drive Rear Drive
Switch Type STEP Setting
Shortcut for Key Assign
Switch CH to SET with up and down key.
Select SET with enter.
Servo Monitor
Front-Rear Drive Ratio
32