Sanwa MT-R RX-493i User Manual page 15

How to Use Each Feature
FUNCTION [FUNC]
● Function can set trim, ALB (Anti-Lock Brake), OFFSET, and TH TYPE (Throttle Type) on each channel.
● By moving the position of the throttle neutral at the time of starting a nitro RC car engine, it improves the
start-up performance of the engine.
● You can fix at a position where idling speed is increased so that the engine will not stop during refueling
your nitro RC car.
● By operating the switch that has been set, you can stop the engine of your RC boat.
● You can use various power sources with Offset feature.
● ON/OFF of the Offset can be assigned to the switch.
OFFSET Position
When setting plus
OFFSET Position
Neutral postion
When setting plus
Trigger Control Input
Neutral position
for Normal
OFFSET Position Neutral
positionwhen setting minus
OFFSET Position
When setting minus
1) Select [OFFSET] with up and down key.
2) Determine with enter operation.
It will change to OFFSET Setting menu.
3) Setting Offset [OFFSET]
Set ON/OFF of the Offset feature with up and down key.
○ Setting Range: ON/OFF
○ Default: OFF
4) Setting Position [POSI]
Set Position of the Offset with up and down key.
○ Setting Range: H100%～B100%
○ Default: 0%
27
SETTING
OFF SET
ENTER BACK
THROTTLE TYPE [TH TYPE]
● You can move the neutrals position of the throttle and set the operating ratio of the forward side and the
brake (backward) side to either 7:3 or 5:5.
*Set the throttle type according to the speed controller to be used.
1) Select [TH TYPE] with up and down key.
2) Determine with enter operation.
It will change to TH TYPE Setting menu.
3) Setting the Throttle Type
Set the Throttle Type with up and down key.
○ Setting Range: F7:B3 / F5:B5
○ Default: F7:B3
*When changing TH TYPE, the screen changes to
the confirmation screen and a message is displayed.
Operate following the message.
ENTER BACK
・NO →Cancel to Change Throttle Type
・YES →Confirm to Change Throttle Type
28