Sanwa MT-R RX-493i User Manual page 4

Structure and the Standard of the Set
STRUCTURE OF THE SET
<Ａ>
Transmitter
<Ｂ> Receiver
<Ｃ> Servo
<Ｄ> Accesories
SET SPECIFICATION
<Ａ> Transmitter
Product No. MT-R (TX-4101)
Output Display
Digital display (Power Source Voltage Display)
Modulation 2.4 GHz Spread Spectrum System
Power Source
AA BATT x4 (Corresponding VOLT: DC4.8 - 7.4 V)
366 g
Weight
*Be careful with the input voltage.
If voltage above allowable voltage is inputted, the transmitter will be damaged.
5 5
MT-R RX-493i PC (Primary Component)
MT-R (TX-4101)
RX-493i
Brake Trigger +1/+2 x each 1
Receiver Dust Cover x1
Bind Plug x1
Antenna Pipe x1
User Manual x1
●Please check items before use
<Ｂ> Receiver
Product No. RX-493i
Modulation 2.4GHz Spread Spectrum System
Size 26.0x23.2x14.0mm
Power Source DC3.7～7.4V
Weight 6.2 g
Before Using
ADJUSTING THE STEERING AND THROTTLE TENSION
MT-R can adjust the tension of the steering/throttle trigger to match operation of the steering/throttle to the user's preference.
Adujsting the Steering Tension
By inserting a hex wrench driver (1.5mm) to the place where the
arrow is pointing at in the illustration on the right and turning, you
can adjust the tension of the steering spring.
*The spring tension is the softest at the time when the product is
shipped out from the factory. As you tighten with a hexagon wrench
driver (1.5mm), the spring tension will be hardened.
Adjusting the Throttle Trigger Tension
By inserting a hex wrench driver (1.5mm) to the place where the
arrow is pointing at in the illustration on the right and turning, you
can adjust the tension of the throttle spring.
*Please do CALIBRATION when changing steering and throtte
tention. (p.48)
ADJUSTING THE ADJUSTABLE TRIGGER
MT-R can adjust the throttle trigger position fiting to the user's hand size.
Adjusting the trigger position
Loosen the fixing screws of the trigger on
the back of the transmitter. Then, adjust the
adjusting screw of the trigger position on the
back of the transmitter to set the trigger at
the position of your preference. When you
turn the adjusting screw of the trigger position
clockwise, the trigger position gauge moves to
the direction A. By turning it counter clockwise,
the trigger position gauge moves to the
direction B.
*The range of the trigger movement is 7mm.
If you turn the screw forcefully beyond the
range, it can cause malfunction. Once you set
the trigger position, tighten the fixing screw
and adjusting the trigger is done.
*Be careful with the direction of turning the
screw because the trigger position is set at the
furthest point of the A side at the factory.
*Setting Advice
Please fit trigger position to your finger naturally.
It would be smoother to operate braking.
Fixing screw of the trigger Fixing screw of the trigger
Adjusting screw for
the trigger postion
Trigger position gauge
Adjustable range: approx. 7mm
6 6