Fcc Compliance Statement - Sanwa MT-R RX-493i User Manual

Service and Support
This is warranted against manufacturer defects in materials and workmanship, at the original data of
purchase. This warranty does not cover components worn by use or damage caused by improper voltage,
tempering, modification, misuse, abuse, improper writing, reverse polarity, moisture or using outside its
intended scope of use.
Terms of this warranty can vary by region. Please read the warranty card included with your radio control
system for specific warranty information.
If you have any questions or concerns, we're here to help. If you encounter a problem with your radio control
system, first chek the Troubleshooting Guide on Page 56.
If you require further help that cannot be solved using The Troubleshooting Guide, or if you have technical
questions, please contact SANWA service center in your region.
For a complete list of distributors in your rgion, please visit
www.sanwa-denshi.com/rc/distributors.html.
For Service In North America:
Serpent America
5121 NW 79 Ave. Unit 03,
Doral, Florida 33166 USA
Telephone: (305)-677-3253
Fax: (305)-675-0415
Email: info@serpentamerica.com
Product features and specifications can vary by region. Not all products are legal for use in all regions.
Please note that products purchased outside of North America cannot be serviced under warranty by
Serpent America. In some cases, we can make repairs for products purchased outside of North America,
however, applicable repair costs and shipping charges will be applicable. For warranty claims outside
North America, please contact the service center in your region.
57
Factory Service:
Sanwa Electronic Instrument CO., LTD.
1-2-50 Yoshita-Honmachi
Higashiosaka, Osaka, 578-0982 Japan
Telephone: 81-729-62-1277
Fax: 81-729-64-2831
Email: rcintl@sanwa-denshi.co.jp

FCC COMPLIANCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the operating instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment OFF and ON, the
user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1)This device may not cause harmful interference, and....
2)This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications made to this equipment not expressly approved by SANWA
may void the FCC authorization to operate this equipment.
RF Exposure Statement:
This transmitter has been tested and meets the FCC RF exposure guidelines when used with
the SANWA accessories supplied or designated for this product, and provided at least 20cm
separation between the antenna the user's body is maintained. Use of other accessories may
not ensure compliance with FCC RF
exposure guidelines.
58