Table of Contents
Advertisement
85103E Upgrade Package (8510A to 8510C)
Installing the Upgrade
Installing the Upgrade
Use this package to upgrade an 8510A (with serial number below 03000) to an 8510C. With
this package, you will do the following:
• Check the 8510A operation.
• Transfer data from tape to disk.
• Install a BNC connector.
• Replace three printed circuit board assemblies.
• Reroute cables.
• Attach new labels.
• If required, upgrade the 8360.
• Reconnect the system.
• Load the 8510C operating system.
• Check the 8510C operation.
• Load and check the calibration kit definitions.
Agilent Technologies does not recommend customer installation of this
NOTE
upgrade. The Agilent 85103E performance upgrade package comes with
prepaid installation. Refer to
for a service engineer to install the upgrade package.
Warranty Information
Installation of an upgrade does not affect the existing instrument warranty in any way.
Specifically, it does not extend the current instrument warranty. Any parts supplied in an
upgrade package carry a 90-day replacement-part warranty.
Source Compatibility
For complete compatibility with revision C.07.00 or greater firmware, your source must be
an Agilent 8360 series source. If an 8360 series source is not used, power domain and
receiver calibration functions will not work.
The 8510C works with all 8360 synthesized sweeper models. However, some 8360
instruments must be upgraded to take advantage of two 8510C system features (quick step
mode and test port power flatness correction). Refer to
NOTE
Agilent 8340, 8341, and 8350 series sources are out of support life and
are no longer recommended for use in 8510C systems.
Please consult with your Agilent customer engineer for more information on upgrading a
network analyzer and source firmware.
2
"Contacting Agilent" on page iv
"Upgrading an 8360 Source."
85103E Performance Upgrade Installation Manual
to arrange
Advertisement
Table of Contents
