Table of Contents
Advertisement
CAUTION: Never use a wire,
needle, or similar object to clean
ODS/pilot. This can damage
ODS/ pilot unit.
Use a vacuum cleaner, pressurized air, or a
small, soft bristled brush to clean.
A yellow tip on the pilot flame indicates dust
and dirt in the pilot assembly. There is a small
pilot air inlet hole about 2" from where the
pilot flame comes out of the pilot assembly
(see Figure 33). With the unit off, lightly blow
air through the air inlet hole. You may blow
through a drinking straw if compressed air is
not available.
Air Passageways
Use a vacuum cleaner or pressurized air to
clean.
• If you remove logs for cleaning, refer to Installing Logs, page 17, to properly replace logs.
• Replace log(s) if broken or chipped (dime-size or larger).
• pilot will not stay lit
• burners will have delayed ignition
• fireplace will not produce specified heat
• propane/LP gas supply might be low (propane/LP units only)
You may feel your gas pressure is too low. If so, contact your local gas supplier.
You may have further questions about installation, operation, or troubleshooting. If so, contact
ProCom Heating, Inc. at 1-866-573-0674.
When calling, please have your model and serial numbers of your heater ready.
200346-01A
CARE AND MAINTENANCE
ODS/PILOT
CABINET
LOGS
SERVICE HINTS
When Gas Pressure Is Too Low
TECHNICAL SERVICE
www.usaprocom.com
Ignitor
Natural Gas
Electrode
Burner
Pilot Air
Inlet Hole
(Back of pilot
shown for clarity)
Figure 33 - Pilot Inlet Air Hole
Exterior
• Use a soft cloth dampened with a mild soap
and water mixture.
• Wipe the cabinet to remove dust.
Thermocouple
Propane/LP
Gas Burner
Pilot Air Inlet Hole
25
Advertisement
Table of Contents
