Clearance To Combustibles; Electrical Connections; Electrical Specifications; Service Instructions - Procom V50TYLA-B Installation Instructions And Homeowner's Manual

CLEARANCE TO COMBUSTIBLES

Back..................50.8mm
Sides.................156.4mm
Floor................ . 0mm
Top................... .610mm
ELECTRICAL CONNECTION
A 10 AMP, 220 Volt,50Hz circuit with a properly grounded
outlet is required. Preferably, the stove will be on a
dedicated circuit. Other appliances on the same circuit
may cause the circuit breaker to trip or the fuse to blow
when the heater is on operation. The unit comes standard
with a 6' (1828mm) long three wire cord exiting from the
rear of the fireplace. Plan the installation to avoid the use
of an extension cord. If an extension cord must be used, it
must be a minimum 1.0 mm
type plug connector and rated no less than 1900 Watts.
WARNING: Disconnect power before
attempting
cleaning to reduce the risk of fire,
electrical shock or personal injury

REPLACING LIGHT BULBS

This fireplace uses two clear 220 Volt, 60 Watt, E-14 socket
base light bulbs (small base, chandelier candle type).The 60
Watt bulbs are located under the log set/ember bed. For
convenience, if one of the bulbs burns out, it may be a good
idea to replace both of the light bulbs.
1. Turn off power to the unit by unplugging the power
cord.
2. Let fireplace cool if it has been operating.
3. Remove the two fixing self-tapping screws on the
screen. Pull the screen upward a little bit, and then
out.
4. Remove the two screws that secure the log set in
position.
5. Examine the bulbs to determine which bulbs need to
be replaced.
6. While holding the socket, unscrew the defective
bulb(s).
three wire with grounding
2
any maintenance or
WARNING: Electrical outlet wiring
must comply with local building
codes and all other applicable
regulations to reduce the risk of
fire, electrical shock and injury.
WARNIGN: Do not use this fireplace
if any part of it has been under water.
Immediately call a qualified service
technician to inspect the fireplace
and replace any part of the electrical
system if necessary.

ELECTRICAL SPECIFICATIONS

Voltage..................220 VAC/50Hz
Total Amps..............6.5 Amps
Total Watts..............1350 Watts
Heater Ratings.........1200 Watts
7. Install the new light bulb(s) by holding the socket
and screwing them.
8. Reinstall the log set and screen. Follow the
above procedure in reverse order.
9. The diameter of the pilot light bulb is 5mm. If the
pilot light bulb need to be replaced, follow steps
1,2,3,4 above. Then use the pilot light bulb
socket w/wiring assembly replace the primary
pilot part, and connect wires according to
primary connection . Then follow step 8 above.
WARNING: Do not exceed 60
Watts per bulb. Use of higher
rated bulbs may result in a fire
causing property damage and
personal injury.
3