Table of Contents
Advertisement
Send Anonymous
Anonymous Call Rejection
Call Log
Special Feature
Feature Key Synchronization
Enable Call Features
No Key Entry Timeout(s)
Ring Timeout(s)
Transfer on 3-way Conference
Hang up
Use # as Dial Key
Conference URI
Broadsoft Call Center
Firmware Version 1.0.1.54
If set to "Yes", the "From" header in outgoing INVITE messages will be
set to anonymous, essentially blocking the Caller ID to be displayed.
The default setting is "No".
If set to "Yes", anonymous calls will be rejected. The default setting is
"No".
Configures Call Log setting on the phone. You can log all calls, log
incoming/outgoing calls (missed calls will not be logged), or disable
call log. The default setting is "Log All".
Different soft switch vendors have special requirements. Therefore
users may need select special features to meet these requirements.
Users can choose from Standard, Broadsoft, CBCOM, RNK, China
Mobile, ZTE IMS, Mobotix, ZTE NGN, or Huawei IMS depending on
the server type. The default setting is "Standard".
This feature is used for Broadsoft call feature synchronization. When
it's enabled, DND, Call Forward features and Call Center Agent status
can be synchronized between Broadsoft server and phone. The
default setting is "Disabled".
If set to "Yes", the call features using star codes on the phone will be
supported locally. Otherwise, the feature code will need to be provided
from the server side. The default setting is "No".
Defines the timeout (in seconds) for no key entry. If no key is pressed
after the timeout, the digits will be sent out. The default value is 4
seconds. The valid range is from 1 to 15.
Defines the timeout (in seconds) for the rings on no answer. The
default setting is 60. The valid range is from 10 to 300.
If set to "Yes", when the phone hangs up as the conference initiator,
the conference call will be transferred to the other parties so that other
parties will remain in the conference call.
Allows users to configure the "#" key as the "Send" key. If set to "Yes",
the "#" key will immediately dial out the input digits. In this case, this
key is essentially equivalent to the "Send" key. If set to "No", the "#"
key is included as part of the dialing string and please make sure the
dial plan is properly configured to allow dialing # out.
Configures Conference URI for N-way conference (Broadsoft
Standard).
The default setting is "No". When set to "Yes", a soft key "CallCenter"
is displayed on LCD dial screen for the Broadsoft account. User can
access different Broadsoft Call Center agent features via this softkey.
GXV3240D Administration Guide
Page 48 of 83
Advertisement
Table of Contents
