Preface; Packing List; Unpacking Instructions; Ac Power - PROEL PLLED185 User Manual

1. Preface

1.1 Packing list

Par Light
Power-line
User Manual

1.2 Unpacking instructions

On receiving a fixture, carefully unpack the carton, check the contents to ensure that all
parts are presented, and have been received in a good condition. Notify the shipper
immediately and retain packing material for inspection if any parts appear damaged from
shipping or the carton itself shows, sign of mishandling. Save the carton and all packing
materials. In the event that a fixture must be returned to the factory , it is important that
the fixture be returned in the original factory box and packing.

1.3 AC Power

To determine the power requirements for a particular fixture, see the label affixed to the
back plate of the fixture or refer to the fixtures specifications chart. A fixture listed current
rating is its average current draw under normal conditions. All fixtures must be directly
powered off a switched circuit and cannot be run off a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer source voltage matches the fixtures
requirement. Check the fixture or device carefully to make sure that if a voltage selection
switch exists that it sets to the correct line voltage you will use.
Warning! Verify that the voltage select switch on your unit matches the line
voltage applied. Damage to your fixture may result if the line voltage applied
does not match the voltage indicated on the voltage selector switch. All fixtures
must be connected to circuits with a suitable Earth ground.

1.4 Safety instructions

Please read these instructions, it includes important information about the
installation, usage and maintenance of this product.
Be sure that the local power outlet match that of the required voltage for your unit.
Do not attempt to operate this unit if the power cord has been frayed or broken. Do not
attempt to remove or break off the ground prong from the electrical cord. This prong is
used to reduce the risk of electrical shock and fire in case of an internal short.
Disconnect from main power before making any type of connection.
Do not remove the cover under any conditions. There are no user serviceable parts
inside.
Never operate this unit when it's cover is removed.
Never plug this unit in to a dimmer pack.
Always be sure to mount this unit in an area that will allow proper ventilation.
Allow about 6 inch (15cm) between this device and a wall.
Do not attempt to operate this unit, if it becomes damaged.
During long periods of non-use, disconnect the unit's main power.
Always mount this unit in safe and stable matter.
Power-supply cords should be routed so that they are not likely to be walked on or
pinched by items placed upon or against them, paying particular attention to the point
they exit from the unit.
1 pcs
1 base
1pcs
10