Ecm (Error Correction Mode); Parallel Memory Transmission - Gestetner F104 Advanced Features

StellaF2_EN_Combine_F_FM.book Page 67 Friday, February 14, 2003 5:16 PM

ECM (Error Correction Mode)

This feature automatically resends
data that wasn't transmitted success-
fully using a system that complies
with international standards.
ECM requires that the destination
machine has the same feature.

Parallel Memory Transmission

With this feature the machine can call
destinations while scanning docu-
ments. Compared with normal Mem-
ory Transmission (where the machine
calls once all the documents have
been stored), it is quick to verify
whether a connection has been made
or not.
Additionally, as scanning finishes
quicker than in Immediate Transmis-
sion, it is useful if you want to take
the document back to your desk im-
mediately. However, if the connec-
tion cannot be made (for example if
the line is busy), normal Memory
Transmission takes place.
Note
❒ Standard Memory Transmission is
used instead of Parallel Memory
Transmission in the following cas-
es:
• When the line is busy and a con-
nection could not be made
• With Send Later
• When you store a document for
Memory Transmission while
another communication is in
progress
• When you send just an Auto
Document
• With Duplex Original
• With Batch Original Documents
Transmission
More Transmission Functions
❒ When the amount of remaining
memory drops below a certain lev-
el, the machine switches to ordi-
nary Memory Transmission and
the Parallel Memory Transmission
feature is disabled until more
memory becomes available.
❒ If you press the { { { { Clear/Stop} } } } key,
the document jams, or memory be-
comes full during Parallel Memory
Transmission, the machine stops
transmitting and prints the Com-
munication Result Report (Memo-
r y T ran s m is si on ). Th e fi le is
erased.
❒ You can switch the Parallel Memo-
ry Transmission function on or off
with the User Parameters. See
p.146 "User Parameters" (switch
07, bit 2).
3
67