Transmission Features; Stamp; Id Transmission - Gestetner F104 Advanced Features

StellaF2_EN_Combine_F_FM.book Page 55 Friday, February 14, 2003 5:16 PM

Transmission Features

Stamp

When sending a fax message, the ma-
chine can stamp a circle mark at the
bottom of the document. This stamp
indicates that the document has been
successfully stored in memory for
Memory Transmission, or that it has
been successfully sent by Immediate
Transmission.
Each time you press the { { { { Stamp} } } } key,
the indicator light is turned on or off.
When the Stamp feature is on, the
light is on; when the Stamp feature is
off, the light is off.
Note
❒ If a page was not stamped when
the Stamp feature was turned on,
you need to resend that page.
❒ When the stamp starts getting
lighter, replace the cartridge. See
p.194 "Replacing the Stamp Car-
tridge" .

ID Transmission

When using this feature, transmission
is limited to destination machines of
the same make and with the same
stored Polling ID. This feature is use-
ful when sending documents contain-
i n g c o n f i d e n t i a l o r s e n s i t i v e
information.
Preparation
You need to program the Polling
ID beforehand. See p.156 "ID
A
Codes" .
Limitation
❒ ID Transmission is not available
with the following functions:
• Polling Transmission
GFSTMP1N
• Backup File Transmission
Note
❒ You can turn this feature on or off
with the User Parameters. See
p.146 "User Parameters" (switch
06, bit 2).
ZHMS160E
Transmission Features
See p.16 "Polling Transmis-
sion".
See p.62 "Backup File Transmis-
sion" .
3
55