Table of Contents
Advertisement
Video
Input Selection
Click this drop-down list to select the desired input.
Setting
Input 1
Input 2
Input 3
Input 4
Auto Switch
Set the Auto Switch mode toggle to ON to enable auto-switching. When auto-switching is enabled, the switcher
will automatically switch to the previous input, if a signal loss is detected on the current input. If a new source is
connected, the AT-JUNO-451-HDBT will automatically switch to that input. The default setting is ON.
HDCP Settings
Sets the HDCP reporting mode of the specified HDMI port: Input 1 = INPUT 1 (HDBaseT), Input 2 = INPUT 2,
Input 3 = INPUT 3, Input 4 = INPUT 4. Some devices will transmit HDCP content if an HDCP-compliant display/sink
is detected. Setting this value to OFF, will instruct the source to send non-HDCP content (if possible) to non-HDCP
display and/or sink devices. Note that setting this value to OFF will not decrypt HDCP content.
Setting
ON
OFF
AT-JUNO-451-HDBT
A/V Settings page
Port
INPUT 1 (HDBaseT)
INPUT 2
INPUT 3
INPUT 4
Description
HDCP content is always transmitted by the source
Instructs the source to send non-HDCP content, if possible
The Web GUI
32
Advertisement
Table of Contents
