Table of Contents
Advertisement
Auto IP mode
If the AT-HDVS-210U-TX-WP is unable to detect a DHCP server within 15 seconds, then the unit
will use a self-assigned IP address within the range of 169.254.xxx.xxx. If this occurs, connect
the AT-HDVS-210U-TX-WP to a computer running Microsoft Windows® and follow the procedure
below.
1.
Click Start > Settings > Control Panel > Network and Sharing Center.
2.
Click Change adapter settings.
3.
Right-click on the adapter that is used to establish a wired connection to the network, and
select Properties from the context menu.
4.
Under the Ethernet Properties dialog box, select Internet Protocol Version 4 and then
click the Properties button.
5.
Click the Use the following IP address radio button.
IMPORTANT: Before continuing, write down the current IP settings in order to
restore them, later. If
server automatically
6.
Enter the desired static IP address or the IP address provided by the network administrator.
If the PC does not require Internet access or if a statically-assigned IP address is being
used, then an IP address of 169.254.xxx.xxx can be entered.
7.
Set the subnet mask to 255.255.0.0.
8.
Click the OK button then close all Control Panel windows.
Resetting to Factory-Default Settings
Resetting the AT-HDVS-210U-TX-WP requires that the front faceplate be removed. Before
removing the faceplate, the AT-HDVS-210U-TX-WP must be disassembled from the electrical box
or mud ring. A small Phillips-head screwdriver is required to remove the faceplate.
1.
Remove the faceplate from the AT-HDVS-210U-TX-WP. Refer to the section
Removal and Assembly
2.
Press and release the Reset button.
3.
Reassemble the faceplate to the front of the AT-HDVS-210U-TX-WP and reinstall into the
electrical box or mud ring.
Obtain an IP address automatically
are selected, then this step is not required.
for more information.
7
Installation Guide
AT-HDVS-210U-TX-WP
and
Obtain DNS
Faceplate
Advertisement
Table of Contents
