Mounting Procedure; Mounting With Standard Fixed Brackets (F39-Lgf) - Omron F3SG RE Series User Manual

Wiring/Installation

4-4-3. Mounting Procedure

 Before mounting (in case of F3SG-RA)
When it is required to configure functions with DIP Switch, do so before installing the F3SG-RA in your
site, according to the procedure described in 3-2. DIP Switch.
The mounting procedure is the same between F3SG-RA and F3SG-RE series.

4-4-3-1. Mounting with Standard Fixed Brackets (F39-LGF)

1.
Loosen the hexagon socket head cap screws (M3 x 15). (Fig.1)
2.
Slide the hook of the Fixed Bracket (1) in the groove of the F3SG-R housing. Lightly tighten the
hexagon socket head cap screw (M3 x 15). (Fig. 2)
Fixed Bracket
3.
Adjust the Standard Fixed Bracket to the mounting position of the wall surface. Securely tighten the
hexagon socket head cap screw (M3 x 15) to fix the Standard Fixed Bracket to the housing of the
F3SG-R. The recommended torque to tighten the hexagon socket head cap screw (M3 x 15) is 2.0
N•m. (Fig. 3)
Tightening screws with a torque that considerably exceeds the recommended torque may cause failure.
F3SG-R
158
User's Manual
Hexagon socket head
cap screw (M3 x 15)
Fig. 1
<Backside mounting>
Optical surface
Lightly
of F3SG-R
tighten this
Slide the hook
in the groove
<Backside mounting>
Securely
tighten this
Adjust the bracket
to mounting position
Fixed Bracket
hook
Loosen this
<Side mounting>
Optical surface
of F3SG-R
Slide the hook
in the groove
Lightly
tighten this
Fig. 2
<Side mounting>
Securely
tighten this
Adjust the bracket
to mounting position
Fig. 3
Fixed Bracket