4-3-2. Mounted with Standard Adjustable Brackets (F39-LGA)
4-3-2-1. F3SG-RA Series
Backside Mounting
Standard Adjustable
Bracket
(F39-LGA)
Standard Adjustable
Bracket
(F39-LGA)
F3SG-RA-30 Series
Dimension A
C1+18
4-digit number of the type name
Dimension C1
(Protective height)
Dimension D
C1-50
Dimension P
Protective height
Number of Standard
(C1)
Adjustable Brackets *1
0190 to 1230
2 *2
1310 to 2270
3
2350 to 2510
4
*1. The number of brackets required to mount either one of emitter and receiver.
*2. Mounting an emitter or receiver with one bracket is possible for the models of protective height of 0160 to 0270. In this case, locate this bracket
at half the Dimension A (or at the center of the sensor length).
4-4-3-2. Mounting with Standard Adjustable Brackets (F39-LGA)
- Use the brackets of specified quantities and locations according to the dimensions. The other brackets than described
above may not meet the specified ratings and performance.
- When you use the sensor in a situation where the sensor is under a load, increase the number of the brackets used.
- The Standard Adjustable Bracket allows beam alignment after fixing the bracket to a wall surface. The angle adjustment
range of the Standard Adjustable Brackets is ±15°.