Additional Installation Items - Gfp 663TH Operation Manual

8B. Remove the Accessories
1. Remove plastic cover, accessory boxes, toolbox and Operator's Manual.
1

9. Additional Installation Items

Remove the shipping blocks and wire ties from the ends of the rollers before
1.
attempting to raise the top roller!
2. Slide the Control Panel boom into the receptacle and tighten the knurled locking collar, Fig. 9a.
NOTE: Make sure the Control Panel is facing the front of the laminator before inserting the
boom and tightening the locking collar.
3. Install the foot pedal, Fig. 9b.
4. Check drive chains for tightness.
5. Check all drive set screws for tightness.
6. Check all electrical connections and input power and test for proper operation.
Control Panel Boom
Boom Locking Collar
Fig. 9a
Gfp 663TH
Control Panel
Receptacle
10
April 2021
Foot Pedal Receptacle
Fig. 9b