Operation; Loading Film - Gfp 663TH Operation Manual

12. Operation

1. Plug power cord into a proper receptacle.

Connect the attachment plug provided with the laminator to a suitably grounded
outlet only. This machine must have reliable earth wire to ensure the safety of the machine
during operations.
 Contact an electrician should the attachment plug provided with the laminator not match the
receptacles at your location.
 Ensure that the voltages of the power supply you are using match the rated working voltages
before operations. Do not use incorrect power supply.
 Do not use damaged wires or sockets. If abnormal conditions occur, switch off the power
supply first.
2. Use the LCD Touch Panel for all functions of the laminator.

13. Loading Film

1. Rotate the locking outer sleeve in the direction of the arrow to the open position, aligned
with the inner sleeve, Fig. 12a.
2. Swing the supply shaft out to load position and slide the film roll onto the shaft.
Note: If using Liner-in film, the web should come off the bottom of the roll, for Liner-out
film, the web should come off the top of the roll (see treading diagram in section #12).
3. Swing shaft back into position and rotate locking outer sleeve to the closed position, Fig 12a
4. Align film roll with a number on the supply shaft, positioning the roll in the middle of the
supply shaft.
Brake Adjustment Knobs
Gfp 663TH
Top Release Liner Rewind Clutch Adjustment Knob
Rear Rewind Clutch Adjustment Knob
28
April 2021
Top supply shaft