Gfp 663TH Operation Manual page 30

6. Use foot pedal to advance the film web until the adhesive is exposed on the front of the heat
roller.
7. Raise the feed tray assembly.
8. Bring the mounting adhesive up to the nip area of the rollers or the media up and behind the
idler bar then tack to the exposed film web adhesive.
9. Lower the feed tray assembly.
10. Use foot pedal to advance both webs until they clear the nip rollers.
Note: The film should be wrinkleless and tight to the surface of the heat roller. If
wrinkles appear in the film web, adjust the brake tension knobs on both supply rolls
6
5
4
3
2
1
Gfp 663TH
7
30
April 2021
1. Bottom supply roll
2. Bottom idler bar
8
3. Bottom nip roller
4. Front in-feed table
5. Top heat roller
6. Release liner
7. Release liner rewind tube
9
8. PSA film supply roll
9. Rotary side slitter
10. Lower rear rewind
10