Installation Safeguards - Gfp 44TH Operating Manual

3. Installation Safeguards

 Shipping damage should be brought to the immediate attention of the delivering
carrier
 Avoid locating the laminator near sources of heat or cold. Avoid locating the
laminator in the direct path of forced, heated or cooled air
 The receptacle must be located near the equipment and easily accessible.

Connect the attachment plug provided with the laminator to a suitably
grounded outlet only. This machine must have reliable earth wire to ensure the
safety of the machine during operations
 Contact an electrician should the attachment plug provided with the laminator not
match the receptacles at your location
 Ensure that the voltages of the power supply you are using match the rated
working voltages before operations. Do not use incorrect power supply

Do not use damaged wires or sockets. If abnormal conditions occur, switch
off the power supply first.

Only a licensed electrician should install wiring and outlet for the laminator
 Do not defeat or remove electrical and mechanical safety equipment such as
interlocks, shields and guards
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is courage to try to correct the interference by one or more of the following
measures:
Gfp 44TH
3
October 2017