Technical Information; Pjlink Protocol - Panasonic PT-RQ13KU Operating Instructions (Functional Manual)

Technical information

PJLink protocol

The network function of this projector supports the PJLink class 1, and the PJLink protocol can be used to perform
projector setting and projector status query operations from a computer.
Control commands
The following table lists the PJLink protocol commands that can be used to control the projector.
f x characters in tables are non-specific characters.
Command Control details
POWR Power supply control
Power supply status
POWR?
query
INPT Input selection
INPT? Input selection query
AVMT Shutter control
AVMT? Shutter status query
ERST? Error status query
Light source status
LAMP?
query
INST? Input selection list query
NAME? Projector name query
Manufacturer name
INF1?
query
INF2? Model name query
Other information
INF0?
queries
CLSS? Class information query
*1 When the optional Interface Board for 12G-SDI (Model No.: ET-MDN12G10) is installed, this corresponds to the input switch for the <SDI 1 IN>
terminal. Switching to the <SDI 2 IN/1 OUT> terminal or the <SDI 4 IN/3 OUT> terminal is not possible.
*2 When the optional Interface Board for 12G-SDI (Model No.: ET-MDN12G10) is installed, this corresponds to the input switch for the <SDI 3 IN>
terminal. Switching to the <SDI 2 IN/1 OUT> terminal or the <SDI 4 IN/3 OUT> terminal is not possible.
206 - ENGLISH
Chapter 6 Appendix — Technical information
Parameter/response
string
0 Standby
1 Power on
0 Standby
1 Power on
2 Preparing for switching off the projector
3 Warm-up
31 SDI1
32 SDI2
33 SDI3
34 SDI4
35 DIGITAL LINK
36 SLOT1-1 (input 1 of the Interface Board installed in <SLOT 1>)
37 SLOT1-2 (input 2 of the Interface Board installed in <SLOT 1>)
38 SLOT2-3 (input 3 of the Interface Board installed in <SLOT 2>)
39 SLOT2-4 (input 4 of the Interface Board installed in <SLOT 2>)
30 Shutter function disabled (shutter: open)
31 Shutter function enabled (shutter: closed)
1st byte
2nd byte
3rd byte
xxxxxx
4th byte
5th byte
6th byte
1st number (1 - 5 digits): Light source 1 runtime
2nd number: 0 = Light source 1 off, 1 = Light source 1 on
xxxxxxxxxxxx
3rd number (1 - 5 digits): Light source 2 runtime
4th number: 0 = Light source 2 off, 1 = Light source 2 on
31 32 33 34 35 36 37 38
―
39
Returns the name set in [PROJECTOR NAME] of [NETWORK
xxxxx
SETUP].
Panasonic Returns manufacturer name.
RQ13K Returns model name.
xxxxx Returns information such as version number.
1 Returns class for PJLink.
Remark
Indicates fan errors, and returns
0 - 2.
Indicates light source errors, and
returns 0 - 2.
Indicates temperature errors, and
returns 0 - 2.
Returns 0.
Indicates filter errors, and returns
0 - 2.
Indicates other errors, and returns
0 - 2.
*1
*2
*1
*2
f 0 = No error is
detected
f 1 = Warning
f 2 = Error