[Lens Calibration]; [Lens Memory] - Panasonic PT-RQ13KU Operating Instructions (Functional Manual)

2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[MULTI DISPLAY]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[PROJECTION METHOD]
4) Press the <ENTER> button.

[LENS CALIBRATION]

Detect the lens shift limit value of the projector and set the home position and the ET-D75LE90 lens standard
position automatically.
1) Press as to select [LENS CALIBRATION].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[D75LE90]
3) Press the <ENTER> button.
f The confirmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f To cancel, select [CANCEL].
f The lens moves up, down, left, and right to detect the lens shift limit value, and automatically set the home
position and the ET-D75LE90 lens standard position.
f The lens stops to complete the calibration.
Note
f [PROGRESS] is displayed in the menu during lens calibration. The operation cannot be canceled during calibration.
f When lens calibration executes correctly, [COMPLETE] is displayed and [INCOMPLETE] is displayed when it does not execute correctly.
f Pressing the <FOCUS> button on the remote control for at least three seconds will also display the confirmation screen for lens calibration
execution.

[LENS MEMORY]

Save and load the focus position, shift position, and zoom position of an adjusted lens.
Saving lens position
1) Press as to select [LENS MEMORY].
2) Press the <ENTER> button.
3) Press as to select [LENS MEMORY SAVE].
4) Press the <ENTER> button.
f The [LENS MEMORY SAVE] screen is displayed.
5) Press as to select the item to save, and press the <ENTER> button.
154 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the <FUNCTION> button.
Switches the [MULTI DISPLAY MODE] setting. (x page 160)
Displays the sub memory list. (x page 165)
Switches the [SYSTEM SELECTOR] setting. (x page 91)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 89)
Temporarily pauses the image. (x page 135)
Displays the waveform of the input signal. (x page 135)
Loads the registered lens memory. (x page 154)
Switches the [PROJECTION METHOD] setting. (x page 138)
Select this item when anything other than the Fixed-focus Lens (Model No.: ET-D75LE90) is used.
Move the lens to the home position after completing the calibration.
Select this item when the Fixed-focus Lens (Model No.: ET-D75LE90) is used.
Move the lens to the ET-D75LE90 lens standard position after completing the calibration.