Panasonic PT-RQ13KU Operating Instructions (Functional Manual) page 182

Item
[BRIGHTNESS SENSOR]
[PHOSPHOR WHEEL1]
[PHOSPHOR WHEEL2]
[QUAD PIXEL DRIVE UNIT]
[FILTER UNIT]
r [WARNING] items
Item
[INTAKE AIR TEMPERATURE]
[OPTICS MODULE TEMPERATURE]
[EXHAUST AIR TEMPERATURE]
[LD1 TEMPERATURE]
[LD2 TEMPERATURE]
[POWER CIRCUIT TEMPERATURE]
[FPGA TEMPERATURE]
[BATTERY]
[AIR FILTER]
[AC VOLTAGE]
[LOW-TEMPERATURE]
[Network status] page
Click [Status] → [Network status].
The current network setting status is displayed.
182 - ENGLISH
Chapter 4 Settings — [NETWORK] menu
There is a problem with the luminance sensor. If problems persist even after switching
on the power, consult your dealer.
There is a problem with the phosphor wheel 1 or phosphor wheel 1 drive circuit. Consult
your dealer.
There is a problem with the phosphor wheel 2 or phosphor wheel 2 drive circuit. Consult
your dealer.
There is a problem with the QUAD PIXEL DRIVE unit handling the function to enhance
the resolution of the projected image, or its drive circuit. Consult your dealer.
The air filter unit is not attached. Check the connection of the air filter unit.
(x page 198)
The intake temperature is high. The projector may be used in an environment where the
temperature is high, such as near a heating appliance.
The temperature around the optics module inside the projector is high. The projector
may be used in an environment where the temperature is high, such as near a heating
appliance.
The exhaust air temperature is high. The projector may be used in an environment
where the temperature is high, such as near a heating appliance. Or the air exhaust port
may be blocked.
The temperature of the light source is high. The projector may be used in an
environment where the temperature is high, such as near a heating appliance.
The temperature around the power circuit is high. The air intake port may be blocked.
The temperature inside the projector is high. The air intake port may be blocked.
Battery replacement is required. Consult your dealer.
There is too much dust accumulated in the air filter. Set the <MAIN POWER> switch to
<OFF> (x page 67), and clean the air filter. (x page 198)
The input supply voltage is low. Use electric wiring that can sufficiently withstand the
power consumption of the projector.
The temperature around the optics module inside the projector is low. Projection cannot
be started until the optics module becomes warm.
Description
Description