Panasonic PT-RQ13KU Operating Instructions (Functional Manual) page 240

Note
f The light output will decrease as much as the power supply voltage is decreased. It is recommended to use with AC 200 V or higher to
prioritize luminance.
r Connecting terminal/slot
<SDI IN 1> terminal
<SDI IN 2> terminal
<SDI IN 3> terminal
<SDI IN 4> terminal
<FRAME SYNC 1 IN/OUT>
terminal
<FRAME SYNC 2 OUT>
terminal
<SERIAL IN> terminal
<SERIAL OUT> terminal
<REMOTE 1 IN> terminal
<REMOTE 1 OUT> terminal
<REMOTE 2 IN> terminal
<DIGITAL LINK/LAN> terminal
<SLOT 1>
<SLOT 2>
240 - ENGLISH
Chapter 6 Appendix — Specifications
Total 4 sets (BNC)
Single link SD-SDI signal
Single link HD-SDI signal
Single link 3G-SDI signal
Dual link HD-SDI signal
Dual link 3G-SDI signal
Quad link HD-SDI signal
Quad link 3G-SDI signal
1 set (BNC)
During input setting
During output setting
1 set (BNC)
TTL output: Maximum 10 mA
D-Sub 9 p, 1 set each, RS-232C compliant, for computer control
M3 stereo mini jack, 1 set each, for remote control (wired)/for projector connection control
1 set, D-Sub 9 p, for contact control
1 set, RJ-45, for network and DIGITAL LINK connections (HDBaseT
100Base-TX, Art-Net compatible, HDCP 2.2 compatible, Deep Color compatible
Total 2 sets (blank), SLOT NX specification, for installing the Interface Board
SMPTE ST 372 compliant
<SDI IN 1> terminal: LINK-A signal/<SDI IN 2> terminal: LINK-B
signal/<SDI IN 3> terminal: LINK-A signal/<SDI IN 4> terminal:
LINK-B signal
SMPTE ST 425 compliant
<SDI IN 1> terminal: Link 1 signal/<SDI IN 2> terminal: Link 2
signal/<SDI IN 3> terminal: Link 1 signal/<SDI IN 4> terminal: Link
2 signal
<SDI IN 1> terminal: Link 1 signal/<SDI IN 2> terminal: Link 2
signal/<SDI IN 3> terminal: Link 3 signal/<SDI IN 4> terminal: Link
4 signal
SMPTE ST 425 compliant
<SDI IN 1> terminal: Link 1 signal/<SDI IN 2> terminal: Link 2
signal/<SDI IN 3> terminal: Link 3 signal/<SDI IN 4> terminal: Link
4 signal
TTL high impedance
TTL output: Maximum 10 mA
compliant), PJLink compatible,
TM