Event Log - LANDTEC Geotech G100 Series Operating Manual

OMG100N1.21

11.0 Event Log

The following events are recorded in the instrument's event log. The event log can only be
downloaded using the additional Analyser Data Manager software. Please refer to the
Analyser Data Manager software manual for further details.
Event
Cold Start/Reset
Firmware Version
Set time
Set date
Re-flash requested
Restore to factory settings
Comms clear memory
Change contrast
Change flow fail current limit
Battery less than critical voltage
RTC date/time invalid
Factory calibration invalid or overdue
Service invalid or overdue
Power on self-test, sensor out of range
User calibration set zero OK
User calibration set span OK
User calibration set zero failed
User calibration set span failed
Attempt to store when readings memory full
Readings memory nearly full
Change logging mode
Change logging mode ID
Flow fail current limit exceeded
Page 42
Data
Type of start (MCUSR, boot_key)
Description
Before and After
Before and After
None
Type
Type 0=Readings, 1=Event Log
Before and After
Before and After
Critical, Actual
None
Date, difference
Date, difference
Channel, reading, limit
Before, After
Target, Before, After
Target, Reading
Target, Reading
Max
Limit, Actual
Status, Interval, Pump time
ID
Limit, Actual
 Copyright Geotechnical Instruments (UK) Limited
G100 Range