Table of Contents
Advertisement
OMG100N1.21
Over range codes
ppm
Predetermined
Pressure
Pump
Regulator flow
Sample tube
Span
Temperature probe
Under range codes
User calibration
Verify
Warm-up self test
Warranty
Zero
Page 48
Over range codes are errors above the maximum
allowed reading and will be displayed with more
than chevrons (>>.>)
Parts per million
Set up prior to use via Analyser Data Manager
software.
Maximum input pressure 300mb maximum flow
250ml.
The device used to transfer a gas sample into the
instrument where that sample is not under
pressure. Select the 'Pump' key on the analyser
to activate.
The regulator's flow is factory set. It only
requires a few turns to open, no adjustment is
available.
Tube used to transfer sample gas from the
source to the analyser.
The point at which the gas analyser is calibrated
when a known concentration of the target gas is
present.
External device to enable the instrument to
display data and record the temperature
readings. This is an optional feature.
Under range codes are errors below zero and will
be displayed with less than chevrons (<<.<)
Users have the facility to calibrate the analyser
between services. User calibration of the gas
analyser will improve the data accuracy in the
range of the calibration gases used.
Checking instruments operation using calibration
gas.
Predetermined self-test sequence to test the
analyser functions which takes place after the
analyser is switched on and lasts approximately
30-40 seconds.
The instrument is guaranteed against defect in
materials and workmanship for a period of 12
months from the date of shipment to the user
and is subject to the recommended service and
recalibration requirements.
The point at which the gas analyser is calibrated
when there is none of the target gas present.
Copyright Geotechnical Instruments (UK) Limited
G100 Range
Advertisement
Table of Contents
