Table of Contents
Advertisement
G100 Range
5.11 Battery/Charging
Note:
Fully charge the unit before use when the instrument is first received or if the
instrument has been in storage for six months or more.
The battery used in the instrument is 2.6 Ah Lithium-Ion cell. The instrument must be
charged using the power supply supplied with your instrument. The power supply supplied
is intended for indoor use only. Please ensure adequate ventilation whilst charging.
Note: The instrument cannot be powered or charged via the USB connector.
When plugged into the power supply the instrument will power on and display charging.
When complete the display will change to show that the instrument is charged. To switch
the instrument ON whilst charging or charged is displayed, the operator will need to press
and hold the power key briefly.
Note: Once the instrument is fully charged, the power supply should be disconnected
from the instrument.
Instrument:
Power Supply:
Note: A full charge will take approximately 4 hours. Typically, a fully charged battery
will last 10-12 hours.
When the instrument is already powered on, the operation is slightly different as the
battery icon changes to a flashing plug symbol. This will stop flashing when the charge is
complete.
Copyright Geotechnical Instruments (UK) Limited
Input 5VDC ± 0.5V(max 1000mA)
Input 100 – 240V ~ 60/50 Hz 120mA
Input 100 – 240V ~ 60/50 Hz 120mA
Output
Output
Output
5V
5V
5V
1000mA 5VA
1000mA 5VA
1000mA 5VA
OMG100N1.21
Page 25
Advertisement
Table of Contents
