Navigation Lights - Quicksilver 875SD Owner's Manual

Quicksilver 875SD — General Information
Please note that operator vision from the helm may be obstructed by high trim angles of the craft,
along with other factors such as outboard engine trim angles, hull trim plane angles, loading and load
distribution, speed & acceleration, transition from displacement to planing mode, sea conditions, rain
and spray, darkness and fog, interior lights, position of tops and curtains, and persons or movable
gear in the operator's field of vision.
Dash Switch Panel
Horn
Forward bilge pump
Aft bilge pump

Navigation lights

14. Navigation Lights
Your boat comes equipped with navigation lighting for use at night or in low visibility conditions. Prior
to running at night, you must install the stern pole light into the socket located on the aft backrest. A
three position switch, located at the helm switch panel, controls the navigation lights. To turn on the
Navigation Lights, push the upper part of the switch forward. This illuminates on the port (red),
starboard (green) and all around light (white) showing other vessels that you are underway. To turn on
the Anchor Light, push the lower part of the switch down. This illuminates the all around light (white),
letting other boaters know that you are anchored at a given location.
Navigation light switch
Courtesy lights
Water pump
Windshield wiper
Windshield washer fluid
The International Regulations for Preventing Collisions at
Sea (COLREG) and the rules of the road require that a
proper lookout be maintained at all times and observance
of right of way be respected. Always be certain to have
sufficient distance to stop or maneuver if required to avoid
collisions.
Navigation Lights "OFF"
Navigation Lights "ON"
Anchor Light "ON"
14
Underwater lights
Bow windlass
USB charger ports