Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Quicksilver 505 Cabin
Summary of Contents for Quicksilver 505 Cabin
- Page 1 505 Cabin Owner’s Manual...
- Page 3 Welcome Congratulations on becoming a new owner of a Quicksilver® boat. This Owner’s Packet will provide important information about the features of your boat and should be, at all times, kept aboard your boat. Take time to carefully review the information in this packet to really get to know your boat.
- Page 4 Information in this publication is based upon the latest production specifications available at printing. Quicksilver® reserves the right to make changes at any time, without notice, in the colors, equipment, specifications, materials and prices of all models, or to discontinue models. Should changes in production models be made, Quicksilver®...
-
Page 5: Table Of Contents
Table of Contents Introduction 4. Carbon Monoxide Monitor ......17 1. Owner’s Manual ..........vi 5. Steering ............19 2. Your Responsibilities ........vi 6. Engine Control ..........20 3. Safety / Warning Labels ........ vi 7. Emergency Engine Shutdown Switch ... 21 4. -
Page 6: Introduction
Introduction 1. Owner’s Manual The material here and the rest of the Owner’s manual packet: • Gives you basic safety information • Describes the fundamentals of boat use • Describes the features of your boat • Describes the equipment on your boat •... -
Page 7: Dealer Responsibilities
The CIN consists of a two digit country code indicating the country of origin of the manufacturer and a unique twelve digit code that provides Quicksilver® vital information about your boat. The CIN must be included in all correspondence related to the vessel. - Page 8 This Limited Warranty does not apply to any Quicksilver® which has been salvaged or declared a total loss or a constructive total loss for any reasons not covered in this Limited Warranty. This Limited Warranty also does not apply to the following items: 1.
- Page 9 Limited Warranties stated. To the extent allowed by law neither Brunswick Marine in EMEA, not the selling dealer shall have any responsibility of the loss of use of the Quicksilver®, loss of time, inconvenience, commercial loss or consequential damages.
- Page 10 Limited Warranty, and the owner must notify Brunswick Marine in EMEA of any Quicksilver® being repaired by an authorized Brunswick Marine in EMEA dealer which has been at the dealership for fifteen (15) days, or of any claimed defect which was not corrected after one (1) repair attempt.
- Page 11 Limited Warranties stated. To the extent allowed by law neither Brunswick Marine in EMEA, not the selling dealer shall have any responsibility of the loss of use of the Quicksilver®, loss of...
- Page 12 Limited Warranty, and the owner must notify Brunswick Marine in EMEA of any Quicksilver® being repaired by an authorized Brunswick Marine in EMEA dealer which has been at the dealership for fifteen (15) days, or of any claimed defect which was not corrected after one (1) repair attempt.
-
Page 13: Basic Boat Dimensions & Specifications
Quicksilver 505CAB — General Information 1. Basic Boat Dimensions & Specifications MAX OPTIONS Manufacturer: Brunswick Marine in EMEA Model: Quicksilver Activ 505 Cabin Design Category: Draft Max (T 0.77m Length of Hull (L 4.81m Overall Height (H 1.64m Length Overall (L 5.02m... -
Page 14: Vessel Stability
Quicksilver 505CAB — General Information 2. Vessel Stability The following maximum load has been used for assessing the stability and buoyancy comprising • Manufacturer’s maximum recommended load per ISO 14946 427kg • Fuel, fresh water, other fluids to maximum capacity of fixed tanks... -
Page 15: Passenger Locations
Quicksilver 505CAB — General Information 4. Passenger Locations Be aware of your footing while the boat is underway. Gelcoat surfaces are slippery when wet. Use extreme Slipping or falling could result in serious injury or death, caution when walking on wet surfaces. -
Page 16: Safety Label Locations
Quicksilver 505CAB — General Information 6. Safety Label Locations... -
Page 17: Deck/Cockpit Layout (Standard Equipment)
Quicksilver 505CAB — General Information 7. Deck/Cockpit Layout (standard equipment) Navigation light (P&S) Bow cleat (P&S) Bow rail (P&S) Port deck trail Cabin window (P&S) Cabin door Grab rail Center cockpit floor hatch Rod holder (P&S) Aft seat handhold (P&S) Cockpit table Stern cleat (P&S) -
Page 18: Deck/Cockpit Layout (Optional Equipment)
Quicksilver 505CAB — General Information 8. Deck/Cockpit Layout (optional equipment) Copilot seat Starboard extended swim platform Back bench filler seat Bimini w/ enclosure (not shown) Cockpit sun lounge Mooring cover (not shown) Port extended swim platform 9. Cockpit Storage Cockpit floor storage... -
Page 19: Thru Hull Locations
Quicksilver 505CAB — General Information 10. Thru Hull Locations Port cockpit drain Bilge pump drain Fuel tank vent Starboard cockpit drain Anchor locker drain Motorwell drains Cockpit hatch gutter drain Garboard drain plug Depending on the type of boat, you may have underwater The deck drains provide self-bailing capabilities while the fittings that need drain plugs. -
Page 20: Cabin Layout
Quicksilver 505CAB — General Information 11. Cabin Layout Navigation light storage Center forward mattress Cockpit table leg storage Starboard mattress CO monitor Filler board (optional) Port mattress Filler cushion (optional) 12. Dash Layout (standard boat) Steering wheel Cup holder 12V receptacle... -
Page 21: Navigation Lights
Quicksilver 505CAB — General Information Dash Layout (optional boat) Active Trim SC1000 Tachometer SC1000 Speedometer Air temperature sensor Please note that operator vision from the helm may be obstructed by high trim angles of the craft, along with other factors such as outboard engine trim angles, hull trim plane angles, loading and load distribution, speed &... -
Page 22: Engine
Quicksilver 505CAB — General Information Navigation lights “OFF” Navigation lights “ON” Navigation light switch Anchor light “ON” 112.5 Port Navigation All Around Light Light (Red), visible 2NM (White), visible 2NM 112.5 Stbd Navigation All around light stored in cabin Light (Green), visible 2NM... -
Page 23: Trailering
Operator’s Manual. Refer to the Engine Owner’s Manual for operating instructions and warranty information. The engines are warranted directly by Mercury, not by Quicksilver®. 15. Trailering Quicksilver® does not offer a trailer for this boat, however, if you plan on purchasing one from another vendor, please consider the following: •... - Page 24 Quicksilver 505CAB — General Information Strong Points Stern cleat (P&S) Bow cleat (P&S) Anchor cleat Bow eye Stern eye...
-
Page 25: Fuel System
Quicksilver 505CAB — System & Component Overview and Operation 1. Fuel System Your boat’s petrol fuel system consists of a fuel tank, a fuel tank fill, a fuel tank vent fitting, an anti- siphon valve, a sending unit, and an engine fuel supply line. In addition, there is a extra fuel port for an optional pickup, if needed. - Page 26 Your boat was manufactured, and shipped from the factory with ethanol compatible materials. Before introducing petrol with ethanol into your fuel tank, ask your dealer if any components have been added or replaced that are not recommended by Quicksilver, Mercury or may not be ethanol- compatible.
-
Page 27: Bilge Pump
Quicksilver 505CAB — System & Component Overview and Operation Storage Long periods of storage and/or non-use, common to boats, create unique problems. When preparing to store a boat for extended periods, disconnect the fuel line. REFER TO THE ENGINE MANUFACTURER’S MANUAL IN YOUR OWNER’S MANUAL PACKAGE FOR COMPLETE INSTRUCTIONS AND WARRANTY INFORMATION. -
Page 28: Fire Prevention
Quicksilver 505CAB — System & Component Overview and Operation If water ever enters the forward part of the bilge, simply remove the drain plug in the PVC pipe located in the forward bulkhead, accessed via the center cockpit floor hatch. Once all of the water has drained, re- install the drain plug. -
Page 29: Carbon Monoxide Monitor
4. Carbon Monoxide Monitor Quicksilver® boats are equipped with carbon monoxide (CO) monitors in the cabin and enclosed berths or staterooms. Carbon Monoxide is an odorless, colorless, and tasteless, extremely toxic gas produced by engines, heaters, stoves or generators. When inhaled it combines with hemoglobin in the blood, preventing absorption of oxygen and is unlikely to be noticed until the person is overcome. - Page 30 Quicksilver 505CAB — System & Component Overview and Operation • Make sure that at all times, there is good ventilation throughout the boat. Open all hatches, portlights, or canvas openings to let fresh air circulate. • Never operate the boat with the canvas enclosure unless there is ventilation throughout the boat (i.e.
-
Page 31: Steering
Quicksilver 505CAB — System & Component Overview and Operation End of Life Signal Your CO detector is equipped with an End Of Life (EOL) signal indicating the sensor used in the unit has reached the end of its service life and must be replaced. The detector contains an electro- chemical sensor that will last approximately 7 years. -
Page 32: Engine Control
Quicksilver 505CAB — System & Component Overview and Operation Mechanical Steering Steering wheel Rotary helm Steering cable If adjustment is necessary: 1. Loosen the bolt on the trim tab. 2. If the boat turns easier to the right, move the trailing edge of the trim tab to the right. If the boat turns easier to the left, move the trailing edge of the trim tab to the left. -
Page 33: Emergency Engine Shutdown Switch
Quicksilver 505CAB — System & Component Overview and Operation Power Trim & Tilt The power trim, located on the side of the gear shift throttle handle, allows you to raise and lower the engine for trailering and launching the boat. It also allows you to adjust the engine to create the optimum run angle for the boat to achieve best all around performance (fuel consumption, speed). -
Page 34: Instrumentation Package
Quicksilver 505CAB — System & Component Overview and Operation 8. Instrumentation Package Depending on the type of engine installed on your boat, you will either have analog or SmartCraft gauges installed. For boats with engines 60HP or less, analog gauges come standard. This gauge package includes a tachometer, speedometer, fuel gauge and an engine trim gauge. -
Page 35: Interior Cabin Filler (Optional)
Quicksilver 505CAB — System & Component Overview and Operation Table base Cockpit Table Table leg Cockpit table 11. Interior Cabin Filler (optional) An optional interior cabin filler is available for this boat, allowing you to convert the forward V-berth area into a full size mattress for sleeping. Simply place the filler boards in the grooved edge along the V-berth. -
Page 36: Sun Lounge (Optional)
Quicksilver 505CAB — System & Component Overview and Operation Back Bench Filler Seat Back bench filler seat Upper handle bar Back Bench Filler Seat in “lounge” position Back Bench Filler Seat rotated forward 13. Sun Lounge (optional) As an option, your boat may be equipped with a removable sun lounge. The sun lounge consists of three removable panels, support legs, and cushions. -
Page 37: Canvas (Optional)
Quicksilver 505CAB — System & Component Overview and Operation Sun lounge may shift while underway. Verify that the outer sun lounge panels are fully engaged into the deck support slots and the center sun lounge panel locks in position. walls. Make sure that the panels are fully engaged into the slots. Place the center panel in between the outboard panels locking the sun lounge into position. -
Page 38: Dc Electrical
The DC electrical system is powered by a single battery, and is kept charged by the engine driven alternator. 2. Battery Quicksilver® recommends AGM type starting or a deep cycle battery for you boat. The battery must meet the minimum capacity required by the engine manufacturer. Refer to your engine owner’s manual for exact battery requirements. -
Page 39: Fuses And Breakers
Quicksilver 505CAB — Electrical Systems 5. Fuses and Breakers Your boat will either have fuses or breakers protecting the DC electrical system. If you have to replace a fuse or electrical breaker, replace only with a fuse or breaker of the same rating. The amperage will be marked on the fuse or breaker, and it is recommended that you carry spare fuses or breakers. -
Page 40: Electrical Schematics
These electrical schematics were generated by the Electrical Engineering Department for technical reference and service technicians. Quicksilver® does not recommend that you attempt to work on the boat’s electrical system yourself. Instead, we recommend that you take your boat to your local authorized Quicksilver®... - Page 41 Quicksilver 505CAB — Electrical Systems DC Wiring Schematic...
-
Page 42: Maintenance
If the growth is more severe, you may need to enlist the services of a professional hull cleaning company. Check with your Quicksilver® dealer for recommendations on a compatible rubbing compound for your boat or a professional hull cleaning company in your area. -
Page 43: Component Maintenance
Frequent routine cleaning of your stainless steel will help maintain the finish. Quicksilver® recommends that you wash stainless steel components with mild soap and cold or lukewarm water after every use of the boat. If added protection is necessary, apply a cleaning wax. - Page 44 Do not store any of the canvas pieces while wet. The effects of ultraviolet light can sometimes be reduced by chemical treatment of canvas items. Consult your Quicksilver® dealer or check your canvas manufacturer’s manual before using any chemical treatments on your canvas.
- Page 45 Quicksilver 505CAB — Maintenance Dry the window with a soft cloth or chamois to prevent water spots. Polish with a separate cloth. Don’t leave cleaners on for long periods; immediately wash the window. Finally, don’t apply cleaners in direct sunlight or at elevated temperatures.
- Page 46 Quicksilver 505CAB — Maintenance THIS PAGE INTENTIONALLY LEFT BLANK...
- Page 47 OWNER’S MANUAL RECEIPT Please fill out the following form, sign it, and give it to the dealer in order to ensure full warranty coverage: Name: _______________________________________________________ Address: _______________________________________________________ _______________________________________________________ _______________________________________________________ _______________________________________________________ Certify that I have received the Owner’s Manual for the following boat: Brand: __Quicksilver ________ Model:...