Bow Thruster (Optional) - Quicksilver 875SD Owner's Manual

Quicksilver 875SD — System & Component Overview and Operation
and allows the anchor to be deployed into the water. The speed of the rode can be adjusted by
turning the handle clockwise. To re-engage the clutch and lock the rode from moving, turn the handle
clockwise.
To manually raise the anchor, loosen the clutch by turning the handle counter-clockwise, and pull the
anchor up into the boat. Make sure to properly feed the rode and chain through the windlass when
pulling up the anchor. When the anchor is up and stowed properly in the bow pulpit, re-engage the
clutch by turning the handle clockwise.
Anchor Windlass

11. Bow Thruster (optional)

The electric bow thruster assists with the maneuvering of your vessel when docking. Access to the
motor and battery is via the forward berth storage area, while the battery switch is located inside the
interior liner floor access panels.
Operation from the helm
To operate the thruster, you first must turn the thruster battery switch to the ON position. At the
helm, press the on/off switch on the control panel. An LED will flash and a buzzer will sound
continuously. Press the on/off switch again within 6 seconds . The system will confirm that it is ready
for use when the LED light remains green and the buzzer sounds twice.
35
Bow windlass
Hand held controller
Windlass switch
Windlass breaker