Table of Contents
Advertisement
Quicksilver 675OP — General Information
12. Dash Layout (optional equipment)
Please note that operator vision from the helm may be obstructed by high trim angles of the craft,
along with other factors such as outboard engine trim angles, hull trim plane angles, loading and load
distribution, speed & acceleration, transition from displacement to planing mode, sea conditions, rain
and spray, darkness and fog, interior lights, position of tops and curtains, and persons or movable
gear in the operator's field of vision.
Dash Switch Panel
13. Navigation Lights
Your boat comes equipped with navigation lighting for use at night or in low visibility conditions. Prior
to running at night, you must install the stern pole light into the socket located on the transom. A
three position switch, located at the helm switch panel, controls the navigation lights. To turn on the
Navigation lights, push the upper part of the switch forward. This illuminates the port (red), starboard
(green) and all around light (white) showing other vessels that you are underway. To turn on the
anchor light, push the lower part of the switch down. This illuminates the all around light (white),
letting other boaters know that you are anchored at a given location.
9
GPS
Water pump switch
Stereo
Active trim
ERC
Bow windlass switch
USB receptacle
DAB radio antenna
Bilge pump
Anchor/ navigation light
Fresh water (optional)
Advertisement
Table of Contents
